Orion 2xx User Manual

FOUNDATION Fieldbus™Operating ManualEnhanced Model 2xxFOUNDATION Fieldbus™Digital OutputSoftware v3.xA Magnetrol CompanyMagnetostrictiveLevel Transmit

746-649 Jupiter Magnetostrictive Transmitter - FOUNDATION fieldbus™2. Position the Jupiter transmitter on the side of the MLIwhere it will be attached

846-649 Jupiter Magnetostrictive Transmitter - FOUNDATION fieldbus™2.5 WiringCaution: The Jupiter magnetostrictive transmitter operates at volt-ages o

8. Power may be applied to the instrument when the installa-tion is complete and has been checked by the instrumentengineer or safety officer.3.0 Func

• The permitted modes are listed for each block.• The block must be in an automatic mode for normaloperation.NOTE: The MODE_BLK target parameter must

DD_REV: contains the revision of the DD associated withthe version of firmware in the Enhanced Jupiter transmitter.It is used by interface devices to

FAULT_STATE, SET_FSTATE, CLR_FSTATE: these onlyapply to output function blocks. (The Model 2xx has nooutput function blocks).MAX_NOTIFY: the maximum n

3.3 Transducer BlockThe TRANSDUCER block is a custom block containingparameters that support the enhanced level transmitter. Itcontains the Jupiter pr

3.3.3 Jupiter Configuration ParametersThis set of parameters within the Transducer Block isimportant and required to configure every Jupiter transmitt

3.4.2 Firmware VersionThe last two parameters in the TRANSDUCER block showthe firmware version of the transmitter.FIRMWARE_VERSION: displays the versi

CHANNEL: The number of the logical hardware channelthat is connected to this I/O block. This informationdefines the transducer to be used going to or

Read this Manual Before InstallingThis manual provides information on the Jupiter®magne-tostrictive transmitter. It is important that all instructions

HI_ALM: The status for high alarm and its associatedtime stamp.LO_ALM: The status for low alarm and its associatedtime stamp.LO_LO_ALM: The status for

When the Model 2xx transmitter is initially powered on,the measurement engine does not have enough valid meas-urement cycles to make a decision about

1946-649 Jupiter Magnetostrictive Transmitter - FOUNDATION fieldbus™5.0 Reference Information5.1 TroubleshootingThe Jupiter transmitter is designed an

2046-649 Jupiter Magnetostrictive Transmitter - FOUNDATION fieldbus™5.1.2 Status MessagesDisplay Message Action CommentOK None Normal operating modeIn

2146-649 Jupiter Magnetostrictive Transmitter - FOUNDATION fieldbus™5.1.3 FF Segment ChecklistThere can be several reasons for a FOUNDATION fieldbus™i

2246-649 Jupiter Magnetostrictive Transmitter - FOUNDATION fieldbus™5.2 Agency ApprovalsFM & CSA 2X1-XXXXXXX-XXX Intrinsically Safe Class I, Div.

46-649 Jupiter Magnetostrictive Transmitter - FOUNDATION fieldbus™235.2.3 Agency Drawing

2446-649 Jupiter Magnetostrictive Transmitter - FOUNDATION fieldbus™5.2.3 Agency Drawing

46-649 Jupiter Magnetostrictive Transmitter - FOUNDATION fieldbus™255.3 Specifications5.3.1 FunctionalSystem DesignMeasurement Principle Magnetostrict

2646-649 Jupiter Magnetostrictive Transmitter - FOUNDATION fieldbus™Inches (mm)Direct InsertionTop MountTop Mount Offset Top Mount OffsetHigh Temperat

Table of Contents1.0 FOUNDATIONfieldbus™Overview ...11.1 Description ...

2746-649 Jupiter Magnetostrictive Transmitter - FOUNDATION fieldbus™5.4 Parts5.4.1 Replacement PartsItem Description Part Number Electronic moduleDis

2846-649 Jupiter Magnetostrictive Transmitter - FOUNDATION fieldbus™5.5 Model Numbers5.5.1 Enhanced Jupiter Magnetostrictive Transmitter2 Enhanced Jup

2946-649 Jupiter Magnetostrictive Transmitter - FOUNDATION fieldbus™5.5 Model Numbers5.5.1 Enhanced Jupiter Magnetostrictive Transmitter200 None, defi

3046-649 Jupiter Magnetostrictive Transmitter - FOUNDATION fieldbus™5.5 Model Numbers5.5.1 Enhanced Jupiter Magnetostrictive Transmitter00No float whe

3146-649 Jupiter Magnetostrictive Transmitter - FOUNDATION fieldbus™Appendix – Transducer Block Parameters5.6 References1. FOUNDATION fieldbus™, A Poc

3246-649 Jupiter Magnetostrictive Transmitter - FOUNDATION fieldbus™Copy blank page and store calibration data for future reference and troubleshootin

BULLETIN: 46-649.1EFFECTIVE: December 2006SUPERSEDES: September 2006Service PolicyOwners of Magnetrol/Orion Instruments controls mayrequest the return

1.0 FOUNDATION Fieldbus™Overview1.1 DescriptionFOUNDATION fieldbus™is a digital communications systemthat serially interconnects devices in the field.

Details regarding cable specifications, grounding, termination,and other network information can be found in IEC 61158or the wiring installation appli

An important requirement of Fieldbus devices is the inter-operability concept mentioned earlier. Device Description(DD) technology is used to achieve

446-649 Jupiter Magnetostrictive Transmitter - FOUNDATION fieldbus™2.0 InstallationCaution: If equipment is used in a manner not specified by manu-fac

546-649 Jupiter Magnetostrictive Transmitter - FOUNDATION fieldbus™2.3 Before You BeginCaution: This instrument is intended for use in InstallationCat

646-649 Jupiter Magnetostrictive Transmitter - FOUNDATION fieldbus™2.3.3 Operational ConsiderationsExterior ambient temperature of the service should